THE Next Generation Hybrid Adhesive

15 November 2019
THE Next Generation Hybrid Adhesive
On this page

Introducing our latest BIS-HY Hybrid Generation 2 chemical anchor. Our BIS-HY Hybrid Gen 2 is an upgrade on our original Hybrid epoxy that has revolutionized chemical anchoring by combining the superior strength of an Epoxy with fast curing characteristics. 

ICCONS BIS-HY Hybrid Gen 2 Adhesive can be used anywhere requiring threaded rod or rebar into concrete. Whether you require anchorage for structural steel connections such as steel beams or columns to concrete, structures such as racking, sound barriers or fencing, our BIS-HY Hybrid Gen 2 is the safest choice. Furthermore, any seismic anchoring, retrofitting structures to concrete or post-installed rebar requirements, our Hybrid Gen 2 is the ultimate choice.

Our original BIS-HY Hybrid had some of the highest load capacity for anchors available on the market, and we have again increased that capacity with our BIS-HY Hybrid Gen 2! Our original BIS-HY Hybrid was the first rapid cure chemical in Australia to have the most stringent seismic anchor testing available globally “C2 approvals” for threaded rod. We have extended that testing to include more sizes for BIS-HY Hybrid Gen 2!

We have not only improved the load performance and technical breadth of our Hybrid we have also enabled it to be used with our Set Safe Dustless Drilling system. Holes not cleaned properly can greatly reduce the performance of chemical anchoring. You can now install our BIS-HY Hybrid Gen 2 with our dustless drill bits and eliminate this element completely. This results in greatly reduced install time by removing the need to clean anchor holes and more importantly has an increased level of Occupational Health and Safety by minimising exposure to silica dust.

Our BIS-HY Hybrid Gen 2 is the most comprehensive adhesive anchor in the market, it is: 

  • Extreme Load Performance
  • Compliant to the National Construction Code 2019
  • ETA Approved
  • C1 and C2 Seismic Tested
  • Fire-rated to 120 minutes
  • Low VOC for green projects
  • AS/NZS potable water approved
  • Water flooded holes approved
  • Approved for use with Dustless Drill Bits
  • Rapid Cure - 3 minute working time and 30 minute curing time (20 Degrees Celcius)
  • Available on our software to design to AS5216:2018 Design of post-installed and cast-in fastenings in concrete

This revolutionary adhesive injection system lends incredible characteristics to almost all adhesive anchor applications in the professional and DIY spaces.